Pricing and billing

1% of verified savings, monthly. Nothing else. No subscription, no seats, no minimum, no setup fee. Installing and running MESH is free and needs no account. A fee exists only after we have agreed billing with you in writing, and only for months in which MESH actually saved you money.

What it costs

The fee is 1% of the net verified savings in a calendar month. You keep the other 99%.

These rows are arithmetic to show the scale, not results:

Your monthly LLM spendIf MESH saves 10%If MESH saves 20%If MESH saves 40%
$10,000fee $10fee $20fee $40
$100,000fee $100fee $200fee $400
$1,000,000fee $1,000fee $2,000fee $4,000

What you would save depends on the shape of your traffic. The measured ranges, each with its label and the command that reproduces it, are on Savings by segment and Evidence. Some setups save nothing, and then the fee is nothing.

When nothing is due

A lever that cost you money in a month is set against the ones that saved you money in that month. Our losses reduce the fee; they are not hidden.

The fee is rounded down to the cent, so it is never more than 1%.

How to start paying

What happens each month

After the month ends, you run one command on the machine where MESH runs:

mesh statement --period 2026-11

It re-checks your ledger's hash chain, recomputes the month, prints the savings by lever and the fee, and writes a statement file. Then:

The billing month is the calendar month in UTC: a request counts in the month it started in. mesh verify and mesh status show the total since you installed MESH, not one month; the month's figure is the one on the statement.

What "verified" means

Each saving is the difference between two costs for the same request.

The rules are published in full in the methodology. The ledger, the price list and the arithmetic are all on your machine, so you can check every line without trusting us.

Currency and tax

Figures are computed in US dollars, the currency the providers price in. The invoice currency is set in the billing agreement. Fees exclude VAT and similar taxes, which are added where they apply.

If you disagree with an invoice

Recompute it. mesh statement --check <file> tells you whether a statement file has been altered since it was written, and mesh statement --period rebuilds the month from your ledger. If the figures do not match ours, send us yours and we use it. The contract terms are in the Terms.